Standard Pool/Spa Fixtures

We install Pentair Amerlite and Spabrite fixtures for pools and spas.  You do not need to drain your pool for us to change the fixture.  

If your pool or spa light is tripping the GFCI, then it needs to be replaced.  It is important for us to check the situation out and make sure that there is not some other cause.

In about 5% of the cases, we encounter light fixtures where the cord is stuck in the conduit.  There is an additional charge in those cases.

Color Changing LED Fixtures

If you are looking to change to color changing LED lights, we have a great alternative to expensive LED fixtures. 

We install standard pool and spa fixtures and install LED bulbs that can operate with a plug in module or can directly simulate an IntelliBrite light and be controlled by electronic control systems.

There are several advantages here:  First, they cost a lot less. Second, if the light goes out after a few years, you just replace the bulb, not an expensive fixture.  The bulbs provide plenty of light and come with a 2 or 3 year warranty.

Micro LED Lights

For new pools or for major remodels we recommend Micro LED lights which fit into a 1.5″ threaded wall fitting.  They provide a better lighting spread with less glare.

These are low voltage and they are controlled by any unit that controls IntelliBrite lights (Pentair controls, Jandy controls or a Pentair switch).

Color Changing LED Pool/Spa Bulbs

These bulbs fit into standard full sized pool fixtures and smaller Spabrite fixtures. 

The InteKit bulbs fit into all standard pool and spa fixtures and integrate with a control module that plugs into any AC outlet and communicates down the neutral line.  They come with a 2 year manufacturer warranty.

The J-J bulbs fit into pool and spa fixtures and simulate an IntelliBrite light.  They integrate directly without a remote module.  They have a three year warranty.

Fiber Optic to LED Conversion

By now, most Fiber Optic pool light systems have long since passed on to that great pool in the sky, if you get our drift.

We can remove those old lights and replace them with LED lights.  They require a 12 volt transformer and a control system. 

We can get different fixtures to be controlled by Pentair, Jandy or Hayward controls.

If you are interested, we can come out and look at the situation and give you a quote.

SunLite Fixture Conversion

If your SunLite fixture goes bad, you will soon discover that it is obsolete and replacements are not available.  

We take the old light ring and retrofit it with a fitting that allows us to install a MicroBrite LED light which can then be controlled by any controller that will run Pentair lights.

This requires a light as well as a 12 volt transformer.